Boss Techie

Firmware updates are supremely important for the performance of a Netgear extender. Users like you understand this. Perhaps, this is the reason why you and many others out there prefer updating the firmware of their networking devices via the mywifiext.net web address whenever a notification appears. However, when they come across the www mywifiext net refused to connect issue; they tend to use the IP address to execute the same process. But, like most of them, did you also become a victim of the Netgear WiFi extender firmware update stuck issue?

Nodding your head in yes? Well, we can help guess all the reasons why you are reading this article. The number one reason why the firmware update got stuck is because your internet connection keeps dropping. You can figure out the rest of them as you read the information given further in the guide.

How to Fix Netgear Extender Firmware Update Stuck Issue?

1. Check the WiFi or Internet Connection

As mentioned in the introduction of this article, you might have been forced to face the Netgear WiFi extender firmware update stuck issue because your internet connection keeps dropping. This might be because of two reasons: Your Internet Service Provider is not doing his job properly and the connection between the extender and the router is weak. Perhaps, the cable connecting them is either worn out or damaged.

In this case, you need to call up your Internet Service Provider and get things in order. Also, ensure that the connection between the devices is stable.

2. Go Through the Right Steps

Another reason why the Netgear extender firmware update stuck issue is not letting you enjoy a seamless performance of your networking device is that you followed the wrong instructions to go about the firmware update process. To reverse this situation, you need to update the firmware of your device by accessing the new extender setup wizard also called the main dashboard.

This time, make sure that only the correct procedure is being followed by you. Once done, it is recommended that you see if the issue at hand has been resolved.

3. Get Rid of Accumulated Cache

Have you ever noticed that accessing a website or when you are already on it, downloading a file becomes next to impossible if the web browser that you are using is outdated or not clean? Well, chances are that you are experiencing the Netgear WiFi extender firmware update stuck issue because of the same damn reason. If you do not believe us, then you may check whether your internet browser is updated.

Taking this into consideration, you should clean your browser by accessing its settings browser by making it free from cache, cookies, and browsing history.

4. Give the Netgear Extender a New Start

In case none of the aforementioned troubleshooting tips help you to resolve the Netgear WiFi extender firmware update stuck issue, then you should get rid of glitches, which is the fourth reason why you are experiencing it. To get rid of them, it is suggested that you reboot your networking device. To learn how to do so, it is recommended that you read the steps in the following paragraph.

To execute the process, you need to power off your extender, wait for some time, and then power on your extender. Make sure that the LED has turned green.

At Last

Here ends the guide written on how to troubleshoot the Netgear WiFi extender firmware update stuck issue. Were you able to get rid of it? No? Well then, the only thing left for you to do now is to reset or restore your networking device to its default factory mode. The same can be done if you locate, access, and press the reset button on the device and wait for about 30 seconds.

As soon as the reset process comes to an end, you can set it up. For this, you can make use of any of the two methods: the WPS method and the manual method. Want to know how to execute the setup process using any of these methods? Well, in that case, you ought to refer to the instructions given in the manual.