Boss Techie

The number one reason why you are unable to update your Wireless-N WiFi repeater to its latest version by accessing the 192.168.10.1 WiFi repeater setup wizard is that you followed the wrong process. Some more reasons could be:

• You have used a damaged Ethernet cable to connect the Wireless-N WiFi repeater to the host router due to which the flow of connection is getting interrupted thereby preventing you from updating your networking device.

• Another reason why you cannot update your repeater is that there is way too much distance between it and the host. Perhaps, you have kept the router in the corner of the house and the repeater is kept in another.

• When you were required to enter the model number of your repeater, you ended up entering the wrong one due to which the firmware got stuck and you got stuck with the Wireless-N repeater not getting updated issue.

Now, that you have become aware of a handful number of reasons why you are facing this issue, it is recommended that you walk through the below-outlined solutions and learn how to fix the issue at hand.

How to Update Wireless-N WiFi Repeater Hassle-Free?

1. Go Through the Correct Guidelines

As mentioned above, the number one reason why you are experiencing the Wireless-N repeater not getting updated issue is that you followed the wrong instructions to update the firmware of your device to its latest version.

To correct your mistake, you ought to walk through the correct guidelines given in the user manual of your networking device. You might have received it while purchasing the device. If you do not believe us, check the box in which the repeater came.

Once you are done following this troubleshooting hack, check if you are able to resolve the Wireless-N repeater not getting updated issue. In case you are still going bonkers because of it, then following the next solution is highly advised.

2. Update the Internet or Web Browser

Another reason why you are stuck with the Wireless-N repeater not getting updated issue, which we did not mention in the introduction of this article, is an outdated web browser. This reason applies to any browser which you are using right now.

Taking this into account, you just need to update your internet browser to its latest version. The same can be done if you access the settings of your browser. For your information, every browser has a different way of getting updated.

So, if you are not sure how to update your device, you should search the web. Apart from this, clean the browser and make it free of accumulated cache. The same can be done by accessing the same option which you did in the last paragraph.

What If Nothing Works?

Considering you are still a victim of Wireless-N repeater not getting updated issue, then your last resort is to reset or restore the networking device to its default factory mode. For this, you need to locate and press the reset button on the device using an oil pin.

Once done, wait for some time. It is recommended that you wait for more than 30 seconds. As soon as the device resets, it will start rebooting. Let it get restarted or rebooted properly. Interrupted the process will take you nowhere.

Apart from this, it is advised that you do not interrupt the process by unplugging your device or powering it off. After the reset process ends, perform the configuration process by referring to the guidelines given in the user manual of your device.

End Note

Now that you have followed the troubleshooting tips mentioned above, there is no harm in assuming that you will be able to resolve the Wireless-N repeater not getting updated issue. In case, you do, then share your feedback.